 |
|
|
|
 |
 |
Dogbone pins slipping out... |
 |
|
 |
|
(#1)
|
|
RC-Monster Stock
Offline
Posts: 19
Join Date: Apr 2011
Location: Sweden
|
Dogbone pins slipping out... -
07.11.2011, 12:10 PM
Got a flux and drive shaft pins on the 11x123mm dog bones are slipping out...
It has happened on 3 different dogbones. Would it help to stick those suckers in there with tire glue? Check out my YouTube channel for some excellent vids of mine and other beasts! |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
RC-Monster Aluminum
Offline
Posts: 897
Join Date: Mar 2010
Location: Same town as "Brand P"
|
07.11.2011, 04:34 PM
sounds like there was a bad batch of dogbones. Im sure HPI would take care of it and send you a good one, just call them and see. On a side note, one of my dogbones did the same thing, i just set it on my vice and pounded it the other way, has been fine since.
|
|
|
|
|
|
|
|
|
|
|
|
|
(#3)
|
|
RC-Monster Stock
Offline
Posts: 19
Join Date: Apr 2011
Location: Sweden
|
07.11.2011, 04:46 PM
yeah, well I lost a pin completely.
gonna bang a chopped off drill bit into the hole tomorrow and see if that holds up. Check out my YouTube channel for some excellent vids of mine and other beasts! |
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Linear Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
