Rustler brushless sytem

My VXL is crap and ramdomly stops moving. No thermals or flashing lights and temps are great. It will just not move if I come to a stop. So it's getting ripped out. I was thinking of a Neu 1506 5500kv finned case with the quark 65amp roadster. what do you guys think. I'm running 5k maxamps 2s lipo.

[lincpimp]

I would go with a mm esc over the quark 65 for 2s lipo. You will most likely overdraw the quark with that motor on 2s. The mm will handle it fine.

Originally Posted by celticclown

My VXL is crap and ramdomly stops moving. No thermals or flashing lights and temps are great. It will just not move if I come to a stop. So it's getting ripped out. I was thinking of a Neu 1506 5500kv finned case with the quark 65amp roadster. what do you guys think. I'm running 5k maxamps 2s lipo.

before I bought a Feigao 9L (2700 kv) for my Rustler, I was thinking about a Neu 1509/1y (3600kv) this was when I was running a 3s lipo
which would have given me 39,960 rpms, but I have since gone to 4s and the rpms would be at 53,280. The Neu could handle it...not so sure about the VXL drivetrain.