 |
|
|
|
|
|
 |
 |
REvo hybrid diff question... |
 |
|
 |
|
(#1)
|
|
RC-Monster Stock
Offline
Posts: 18
Join Date: Feb 2008
|
REvo hybrid diff question... -
02.03.2009, 01:33 AM
I am in the process of installing these. Question though--how do you keep the input shaft ball bearing (the one on the outside of the diff case) from popping out?
|
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
Supermaxx
Offline
Posts: 2,031
Join Date: Oct 2007
Location: Earth
|
02.03.2009, 01:56 AM
They're kept in place by the yoke/driveshaft.
Predator with OS .21TM Supermaxx with Mach .26 Revo with OS .18TZ Kyosho ST-RR Conversion Ofna CR with Tekin ESC/Motor (2) |
|
|
|
|
|
|
|
|
|
|
|
|
(#3)
|
|
RC-Monster Stock
Offline
Posts: 18
Join Date: Feb 2008
|
02.03.2009, 12:05 PM
You seat the yoke all the way against the bearing?
If I put the set screw of the yolk on the flat part of the input shaft, the space between the base of the yolk and the bearing is more than enough for the bearing to pop out. |
|
|
|
|
|
|
|
|
|
|
|
|
(#4)
|
|
RC-Monster Mod
Offline
Posts: 6,597
Join Date: Apr 2007
Location: NJ
|
02.03.2009, 12:23 PM
Extend the flat spot...
|
|
|
|
|
|
|
|
|
|
|
|
|
(#5)
|
|
RC-Monster Stock
Offline
Posts: 18
Join Date: Feb 2008
|
02.03.2009, 01:09 PM
Oh, I didn't realize I needed to slightly mod the input shaft.
Thanks. |
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Linear Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
