medusa 36-60/3100 end bell failed

hello everyone, well medusa has left the seen"RIP".ive been enjoying this motor for a few months and not a single problum, then at our sunday club race today the end bell popped off . So my solution was to set it back in place then pull it back and aply a beed of metal JB weld around the rim and push it in untill bottomed and hope for the best .anyone have a more or better fix to this problum.the internals looked ok ,though i couldnt get the rotor out and didnt want to force it. thanks and have a safe Labor day

[Arct1k]

rcm heatsink will cure it...

[E-Revonut]

BrianG did a thread not to long ago where he installed a couple screws as well

[BrianG]

Here it is: http://rc-monster.com/forum/showthread.php?t=22763

[eovnu87435ds]

i think krawlin had the issue with a 36-70 medusa, and epoxy'ed it back on. it worked great afterwards, but i agree with Arct1k, The heatsink will be a good insurance purchase