Brushless Jammin!!! - RC-Monster Forums

**Brushless Jammin!!! -** 04.16.2006, 10:25 AM

Hey guys, I'm going to be building up a brushless Jammin X1-CR Buggy! Anyone have experience doing it? I think it's going to be relatively simple to do, I'm going to make a mounting plate over the center diff (replacing stock). The center plate is going to be the hard part, I'll probabely bang one out in bronze plate first as a prototype and then get a machinest to make it (I may even sell it if it works well). Well, just wanted to get this thread started to document progress and get some input!

squeeforever · 04.16.2006, 10:32 AM

i believe blackhawk444 is also doing this. what brushless setup are you goin for?

MetalMan · 04.16.2006, 01:23 PM

If it uses the standard Ofna diff, then you can use the plastic spur gear from Kyosho for the Landmaxx. cspurlock uses it on his Ofna differentials, and I too will be using one on a Hyper 7 diff in my 1/8 buggy.

Serum · 04.16.2006, 01:29 PM

The spur from the landmaxx is rather tough too, it is that red spur right? with the steel collar? it eats its way thru the pinions.

MetalMan · 04.16.2006, 02:49 PM

I don't think it is a red spur gear. cspurlock has it on the Hyper 8 in this thread:
http://www.rc-monster.com/forum/showthread.php?t=2868
That gear is black.

squeeforever · 04.16.2006, 02:52 PM

i did a little research and the only one i could find was red.

vad · 08:32 PM

Quote:

Originally Posted by MetalMan

I don't think it is a red spur gear. cspurlock has it on the Hyper 8 in this thread:
http://www.rc-monster.com/forum/showthread.php?t=2868
That gear is black.

Kyosho has two plastic gears. The one form the landmax is IF147 which is a 44T, and the mp-7.5 sport buggy uses the IF148 which is a 46T. Landmax use to have a red gear, but not sure what the tooth count on that is.