So confused

[toby]

Firs ti like the new picture/slogan on the site "go brushless or get smoked" LOL on to my issue though

So i have two emaxxes now, and i want to sell one. I want to take parts off of truck 1 and put them on truck 2.

truck 1 has hybrid bulks with 8 spider gears in them which is what i want off of it, so i went to put them on truck 2 which has flm bulks and stock diffs.

So i am going to switch the diffs around, put the stock ones on truck 1 and the upgraded ones on truck 2.

It wont work though because i cannot use the stock drive shafts on truck 1 because it has an extended chassis, so i was going to keep the upgraded ones on there. But i cannot put my dog bone cups onto the stock thing that comes outta the diffs because my dog bone cups are for the 8 spider

is there anything i can do to put dogbone cups onto the stock diffs?:010:

[Serum]

yeh, you can get UE cups for them.

You know your post could have been 98 percent smaller? :p

[toby]

i am an idiot and was confused at the time, after i spent some time relaxing i figured it out

[coolhandcountry]

Was you just having one of them moments. I hate it when I have one.
Did you have some cups around or figure out a way around it?

[toby]

just one of those moments i guess.

I ended up looking through some of my emaxx aprts and i had some cups, fitted it on and it worked!

Now for my standard length emaxx. what driveshafts should i get for it i nthe center?

[toby]

or if i am going to be racing should i extend it abit since i am running burhsless and 16 cells?

[coolhandcountry]

I like the extended ones. for the shafts I like the ue titanium ones. Have to get mike to get the reg length ones or if you go extended one you good shape.

[Sylvester]

Id go extended, i dont know how i would keep my wheels down with my revo, its already crazy as is!