Strobe slipper

[rchippie]

This is a tip for anyone using the strobe slipper. If you look at your (BLACK) diff ring mounting plate you will notice there is a reasesed section on each ring plate. This allows your bearing to slide back & fourth after some time. Simply put a few shims on each side of your slipper, enough to fill up th reasesed section. This keeps you bearing centered in your slipper & helps keep your slipper from wobbleing. This directions are on the strobe site. I just wanted to make sure everyone knows this tip.

[killarevo]

what is the strobe site?.......thanks

[neweuser]

If you are looking for the slipper clutch parts from there they are also out of stock of everything...

[killarevo]

so what is the site address?......thanks

[neweuser]

I believe they ony use distributors

[coolhandcountry]

www.strobe-rcracing.com
This I believe is it.

[killarevo]

thanks for the info!

Does anyone know what the blue stuff from the sprong is called?