 |
|
|
|
 |
 |
 |
|
 |
|
(#11)
|
|
Yip Yip Yip...
Offline
Posts: 1,489
Join Date: Aug 2007
Location: Australia
|
06.30.2008, 10:41 PM
I sent mike an e-mail on the weekend about getting a mount made. I haven't heard back yet. Thanks for the measurements. I just measured with a ruler as I don't have callipers so it's good to know my measurement is correct. I was hoping that if there was another buggy with the same bottom mount hole spacing I could just replace the entire diff mount with the diff mounts for the other buggy to test the fit and if it worked I would get that motor mount. Sadly I didn't send mike the dimensions as I didn't even think of it at the time.
Mini-T Pro: Micro Pro 6800kv, Lipo, HS-81mg, Dirt Hawgs M18MT: Quark 33A, Y22S 6000kv, FP 2s Lipo LRP S8-BX: RC-M Conversion, Tekin RX8 B1600KV, 6S. |
 |
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
