Manne´s Flux bash build

[Manne]

And mounted the bellcrank by using a bulkhead brace with the holes updrilled to 4mm:



Mounted:



After that I tried to mount my 23mm hubs from the Revo with Lst cvds...That didn´t turn out too good, I had forgotten that the savy doesn´t have the regular 1/8 setup when it comes to hubs... So I ordered some new ones.

Revo Vs Flux, Flux uses the bigger brighter ones:






I also mounted the rear tierod eliminators, sadly I didn´t get the version I wanted ( wasn´t in stock ) so I got this one with a hole that makes the hub weaker....But it has been holding up great so far:





After that I made a mount for my MMM:




And installed the "braces" from the motor mount to stiffen up the chassis and to have something to mount the escplate on: