Quark setup assistance

Hey all,

Not really new here as I have surfed around here for awhile. Im doing a project conversion where i want to use 3 to 5s 5000mah lipos, a 8xl feiago motor, and my esc of choice is a quark 125b. This should be plenty of power to fuel the motor and the esc should handle all aspects of it.

I read in a review that the BEC on the esc should be turned off. I cannot find a section of that in the manual. Also, assuming that the bec can be turned off via the esc as a setting, would all i have to do is hook a 2s lipo up to a voltage regulator and hook it up to the rx's battery port (under channel 1?) or would I have to wire it into the battery/ esc input wires? I have read conflicting views on this but I would like to know for sure. :032:

thanks in advance!