Mugen MBX5T Conversion - Suggestions/advice

[Arct1k]

Caution on new mugen mount - A few issues with the mount at the moment on my MBX5T....

1) The lower mount screw holes weren't long enough - Easily enough to recitify with cutting down the screws
2) The holes that the servo mount slots into weren't quite big enough - Easy fixe by enlarging the holes by running a 4.5mm drill bit in for a minute
3) The motor mount adjustment isn't wide enough - The truggy has a 62t spur - I can't get any pinion on... The mount need to be much wider. - Stumped!

I've attached some pics below:

http://s168.photobucket.com/albums/u180/Arct1k/104.jpg
http://i168.photobucket.com/albums/u180/Arct1k/103.jpg
http://i168.photobucket.com/albums/u180/Arct1k/102.jpg
http://i168.photobucket.com/albums/u180/Arct1k/101.jpg

Cheers