RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > Brushless

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Temp. question
Old
  (#1)
magman
RC-Monster Dual Brushless
 
magman's Avatar
 
Offline
Posts: 4,236
Join Date: Dec 2007
Location: Cape Cod, Mass.
Temp. question - 08.08.2008, 07:13 PM

Ran my mbx-5 buggy today:

Set up:
1. 9xl, geared 44/16
2. MGM esc
3. Badland buggy tires
4. EXTREMELY soft sand

Temps after 15min of hard running:

1. 9xl 170 ( I know this runs hot )
2. MGM 145
3. Batt. 125

I would like to go down to a 15 pinion, for more low punch, but, w/the motor running so hot , I don't know if I dare.... opinions please...

All in all, good/bad? Where I run is a small, tight track w/ very soft sand. So i am figuring that the soft sand is causing some of the motor temps. to be a bit higher.

My 1512 1YF is being repaired and should also run a lot cooler than the 9XL.


1. MBX-6 T8 1900KV, RX8 ON 4S
2. MBX-5T 1520, MMM ON 5S
3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S
4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S
5. TEN T 2650 T8, MMP ON 3S

Last edited by magman; 08.08.2008 at 07:14 PM.
   
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com