RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > Brushless

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old
  (#10)
Rivermaxx
RC-Monster Aluminum
 
Offline
Posts: 638
Join Date: Sep 2008
11.17.2009, 10:19 PM

I will lengthen my distance to get to the traps. Downforce only works if you can get to the speed to utilize it. I am not even getting to those speeds before I loose traction. I am sure if I had a stickier rubber tire that would not blow apart at speed it would be better. My truck weigh ~11 pounds and heavier then 90% of the other vehicles out there. But My motor is able to put out more torque and power than 90% of the other cars also. My bigger diameter tires should have alot more traction than a little > 3" tires the other cars are running also. Bigger = more contact on the ground.

As an example is a f1 car has very little torque lots of hp and still can go 240 mph if given enough room to get up to speed. Where a dragster can get past that speed in less than a 1/4 mile and has extreme torque but if it has no traction it isn't going anywhere. I am thinking for speed runs a smaller castle 1512 2650 motor would be better than a neu 1515 1.5 d 2700 kv motor. Especially in traction limited circumstances. What good is all that power if I have to let off because I am going through through the finish line sideways .
   
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com