Monster GT Conversion With A Center Diff

[Krawlin]

Somewhat bad news, I just realized that plasma cutters have about an 1/8'' cutting width (roughly), so it would probably cut the holes way too big (the 4 small ones at the middle and bottom of the motor plate, and top plate). So I will probably have 1 cut with the holes just to see how it looks, and if it fails, then I'll delete the 4 smaller holes on the motor plate and the two holes on the top plate, and narrow the 3 motor holes. I might also have to get rid of the heatsink fins, depending on how they turn out on the first one I have cut out.

Expect pictures of the close to finished product tomorrow night.