Quote:
Originally Posted by JThiessen
Those Flextek's sure look nice. Will be interesting to see how the hold up to heavy bashing.
I'm putting this part together so I can get more measurements for the design part - gonna need to get some custom shafts made. Anyone know if mike can do shafts that will mount to the LST style center drive cups?
Gotta order some additional carrier pins for the front, and some XXL carrier bearings. Just about done spending bucks on this thing - I'd hate to add up all that I've spent on it so far - gotta be over a grand so far. Kinda wondering why I even bought the roller in the first place - I think I'll only end up using the shock towers, bumpers, and a couple bearings off it!!!
Couple more pics...
|
I ran into the same thing when I put the Dynamite knuckles and carriers on my LST project. The best thing I found were some plastic washers at my local hardware store.
On a side note with the pins, I once saw some that didn't use the e-clips. They were like a shoulder screw and used a nyloc nut. I haven't had any luck finding them again though.
-JB
Threaded Mode
