Maxx 3.3 Steering Blocks

[Gustav]

I got the rear diff assembled and the rear end back together and i don't see any problem at all,they're spot on.

I took the shafts down in the lathe to 3.5mm from the centre of the bevel gear pin hole,the same as the original outdrive.

All i had was 20k oil so i used that but only just over half full since it's a little thick.Now i just need my chassis to arrive and i'm ready to go.:027:

Off topic but I need a body to use on the non-extended g-maxx.Any suggestions? I want to cover the batts as much as possible,i know it won't cover them completely.