 |
|
|
|
|
|
 |
 |
A question |
 |
|
 |
|
(#1)
|
|
Always Willing to Obtain More Knowledge
Offline
Posts: 1,482
Join Date: Oct 2006
Location: Chicago
|
A question -
11.22.2006, 06:52 PM
Were(maby tell me or show link thanks) and how much are the 40mm fans that work with the cnc machined esc cooling heat sink. [URL="http://www.rc-monster.com/proddetail.php?prod=RCM008"] also this fan that you direct me to or recommend to get, does it have low enough voltage to not make a noticable difference in run times. Also if it is three pronged i just use a y joint right! but if it is not 3 prong (like servo useualy uses) how do i make it 3 prong or is there a better way to wire it. Also a pic who has this setup. It would be nice to se
|
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
