|
02.22.2007, 01:11 AM
To keep solder from wicking along the braid, I just used an amount of solder that didn't allow it to travel too far. My iron is pretty hot (I set it ~750-800 deg.), but I hold it for more than 5 secs. sometimes.
I never did get any pics of the process, unfortunately. The first time I wasn't sure if it would work (didn't know if it would be worth it to document the process), and the second time I was under time pressure so I couldn't get pics/do a writeup. If anyone wants me to build a pack for them, I'd be glad to document the process at the same time :).
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|
Threaded Mode
