MGM Compro 16016 - NEED HELP

[MikeyLikesItSI]

I can adjust endpoints (MX3 radio setup). This radio combo is the only one i've programmed/used with the ESC. I tried backing the EPA on the transmitter to 90%, the difference was almost none

Does anything need to be changed when using a 4 pole motor? I had that BEC problem with it but i don't think it would have effected the controller (seperate circuit), besides, the BEC still works.

Also, the MGM manual states that automatic timing should not be used with high inductance motors (5 or 10 deg should be used). Is the Neu 1515 1y considered high or low inductance?