Need help with 1st BL setup in Emaxx!!

Wow, those are great pics... thanks for the instructions suicideneil. You have been a huge help to me thus far. I appreciate it.

[suicideneil]

No problem, just let me know were to send the bill to....:027:

[Serum]

Thanks Neil.

That are the notches i am talking about.

[suicideneil]

I aim to please. I do recall a thread about modifying older A-Arms, but I couldnt find it so I just snapped a few pics of my spare 3.3 A-arms.
You only need to make a notch on one side of the upper arms, then fit them to the truck with the notch facing downwards. Post up some pics when you're done- we like pics around here, we like them alot.....

haha..... I will post some pics when I am done. I just have to wait a week or so for the shafts arrive!!

I also just made the purchase of:

Wanderer 8XL
Heatsink XL size
Strobe Slipper Kit
nylon 51t spur gear
5mm, mod1 16t pinion
FLM diff cup for rear

The steel idler was all sold out, but thats ok

and on ebay I got:

3.3 shafts, and centers
3.3 knuckles
3.3 diffs
tranny with motor mount, cover, and "steel upper gears". (hope they mean idlers)

I got the MM esc, so hopefully this is all I need to get the ball rolling! Thanks again to everyone for there help, this forum is great!

[Serum]

Good to hear BL; but you only bought 1 FLM cup? i would take two; with braking or bad landings the front one gets some punishment too. But you can always replace the stock, but it will cost you gears.