Which Neu motor with 5S and Quark 125

[ssspconcepts]

Originally Posted by neweuser

I can run 5s with no issues, but it gets a tad warm compared to the 4s. And the Quark is rated for 6s, but cannot do it well. 5s is about the most you want to go on the quark. If I hada motor with a lower kv, it would be even better, my current kv is 2200...which is the reason why it runs warmer than my likings.

Thanks. Just curious...what are your runtimes on 4S and what is your approximate top speed?

[neweuser]

Originally Posted by ssspconcepts

Thanks. Just curious...what are your runtimes on 4S and what is your approximate top speed?

On 4s, about 25 min maybe more, top speed most likely 30's, not quite sure. 5s, I get about a half hour, top speed a little more maybe like upper 30's.

[ssspconcepts]

Does anyone know if the NEU 1515 series of motors fit on the stock emaxx motor plate? Or, is it necessary to custom drill mounting holes?

[neweuser]

Originally Posted by ssspconcepts

Does anyone know if the NEU 1515 series of motors fit on the stock emaxx motor plate? Or, is it necessary to custom drill mounting holes?

I could check when I get home if they line up? Or if someone knows right off hand.

[ssspconcepts]

Originally Posted by neweuser

I could check when I get home if they line up? Or if someone knows right off hand.

I would APPRECIATE it SOOOO much if you would check and let me know. Thanks.

[neweuser]

Originally Posted by ssspconcepts

I would APPRECIATE it SOOOO much if you would check and let me know. Thanks.

You bet, I'll be home by 6:00PM tonight and will take a look.

I have a 1521 on my Savage, it has the standard holes. The case is the same as the 1515 only 0.6 inches longer. It will bolt up fine.

[ssspconcepts]

Originally Posted by knotted

I have a 1521 on my Savage, it has the standard holes. The case is the same as the 1515 only 0.6 inches longer. It will bolt up fine.

Thank you! How do you like the 1521?