Locking the revo in 2nd gear to use motor braking/reverse

[jnev]

Again, the screws I though were right, were wrong. So I was finally able to go buy the right ones... and they fit!! Hurray!!

Just thought I would let everyone know that If I can do this mod, anyone can.

Bad news though, is that the bits I have for the drill are not sharp/hard/strong enough to drill through the shaft. So as of right now, I still have the stock pins in. Any recommendations on really hard drill bits?

[jnev]

Originally Posted by jnev

Bad news though, is that the bits I have for the drill are not sharp/hard/strong enough to drill through the shaft. So as of right now, I still have the stock pins in. Any recommendations on really hard drill bits?

Anyone??

Just a little question about the mod jato pin to secure the gear in the revo tranny.
Somes guys here talk about the Jato outdrive pin, but can i use the revo drive shaft pin? (the one who secure the drive shaft to the diff output)

Thank's

David