 |
|
|
|
 |
|
|
 |
 |
|
 |
|
(#1)
|
|
Guest
Posts: n/a
|
10.03.2007, 11:09 PM
I can't take credit for this dogbone setup because it has been around for awhile.
HPI A549 Axle http://www2.towerhobbies.com/cgi-bin...?FVSEARCH=a549 HPI 72072 Dog Bone (order 2) http://www2.towerhobbies.com/cgi-bin...FVSEARCH=72072 HPI 72108 Drive Cup (order 2) http://www2.towerhobbies.com/cgi-bin...FVSEARCH=72108 This works pretty good, way better than MIP CVD's. You can use O rings or better yet a couple of millimeters of fuel tubing to center the dogbones. Just put it in the drive cups on each side. |
|
|
|
 |
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
