My CRT.5 conversion

[gizzmo79]

Originally Posted by IBJAMMIN

There the Jammin upgrade aluminum part's I got the steering rack and front and rear hubs from www.nitrohouse.com and I found the aluminum ball ends at RC4WD the Titanium turnbuckles are Lunsford. :027:

Can you pleas let me know witch turnbuckles i need to order?

[IBJAMMIN]

Originally Posted by gizzmo79

Can you pleas let me know witch turnbuckles i need to order?

Look on page 5 about 3/4 of the way down I listed all the info on the Lunsford TB info. :)

Sorry I have been busy with my new toy a 2007 Yamaha FZ1 I got tired of making RC cars go a 100mph and decided to see what 170mph feels like.

[BP-Revo]

Originally Posted by IBJAMMIN

Look on page 5 about 3/4 of the way down I listed all the info on the Lunsford TB info. :)

Sorry I have been busy with my new toy a 2007 Yamaha FZ1 I got tired of making RC cars go a 100mph and decided to see what 170mph feels like.

Get a Kawasaki ZX-14 and tune it and you can feel what 9 second 1/4 miles and 220mph feels like

My dad has one of these and its absolutely STUPID fast...

My favorite of his bikes is his 04 R1 tuned to 200hp (crank). Best of every world.

[gixxer]

Originally Posted by IBJAMMIN

Sorry I have been busy with my new toy a 2007 Yamaha FZ1 I got tired of making RC cars go a 100mph and decided to see what 170mph feels like.

To me it all felt the same after about 140mph. Basically just hanging on

I haven't run my crt.5 for many months, but today I tried it out and found the servo didn't quite center when turning one direction. It is a Hitec HS-5245MG that was sent back to Hitec once because it didn't center well... now it is doing it again. I've heard about a weaker servo saver spring that is easier on the servo. Where is this available? What servo is recommended without going to the extended chassis. I don't want to spend $40 on a chassis just to fit a larger servo.

Chad