 |
|
|
|
 |
 |
 |
|
 |
|
(#5)
|
|
Guest
Posts: n/a
|
11.15.2007, 01:09 PM
I have sent 3 e-mails to them in the last 3 days with no response.
Could someone post a side shot of the chassis so I can make the bend. If possible take a measurement from either the front or the rear of the plate to where the bend starts and a measurement of the rise on the bend so I can rectify the issue. Thanks for the quick reply. Im looking forward to getting this project underway again. -Ed |
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
