RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > Brushless

Reply
 
Thread Tools Rate Thread Display Modes
Old
  (#1)
bluesilver
Guest
 
Posts: n/a
12.08.2007, 05:53 PM

Thanks for the info.
I have it set for 9v cut off. the battery is at 11.7V only because I have been running around with it for a while trying to figure out what was going on.
Fully charged they are about 12.6V from memory.

The battery is a maxxamp battery.
I get the same problem if I go from 0- full throttle slowly or stright away.

I have just ben going over my instructions again last night.
It appears that I have missed a step in the programing ( programing by transmaitter)
Apparently I have to set the Automatics tunning when I have done everthing else.
It tells be to run the car at full throttle for a least 2 seconds.

Could this be the problem why I am not getting full throttle?

I can't try it out today as it is raining. will have to wait untill it clears up a bit.

Last edited by bluesilver; 12.08.2007 at 05:54 PM.
   
Reply With Quote
Old
  (#2)
Finnster
KillaHurtz
 
Finnster's Avatar
 
Offline
Posts: 2,958
Join Date: Apr 2006
Location: Bucks Co, PA
12.08.2007, 05:59 PM

Sounds like a LVC issue to me. You could always reprogram. Try it set to 6V and see if it works. The fact that it stops doing it in "race-mode" where all safeties are off tells you its a safety feature kicking in, and I don't think its a current limiter w/ your setup.
   
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com