just an FYI....
i used a 52t monster GT mod 1 spur and it bolts right up to the slipper. i am running 14/52 and its 35mph on the gps with no heat at all after a full 20 mins, perfectly racable.
also the new maxx has a 2ch tx and a 4ch rx(with 2 plugs for ch1), which seems a little odd
Last edited by emaxxjeremy; 12.30.2007 at 12:08 AM.
2 plugs for channel 1 would make sense if there was 2 steering servos, which there is, isn't there?
squee you are absolutely correct. i talked to a guy at the hobby expo and he said there are two slots for the servos in the receiver but both of them go to the same channel eliminating the need for a y harness.
just an FYI....
i used a 52t monster GT mod 1 spur and it bolts right up to the slipper. i am running 14/52 and its 35mph on the gps with no heat at all after a full 20 mins, perfectly racable.
also the new maxx has a 2ch tx and a 4ch rx(with 2 plugs for ch1), which seems a little odd
what motor are you running in the truck? maximum ? what kv.
phil
makes sense the speeds you got with that gearing as the maxximum has a higher kv right around 2800-2900 from what I could find. so I guess I'll just gear up.
phil