Another FLM Conversion Build-Help

Rotating the motor to position the wires down sounds like a good idea. It looks like you may run into some interference with the TVP though. Aren't the wires flexible? If so I would go with bending them and using heat shrink as BlackedOutREVO and jhautz said. Keep us posted on this. I am installing the same motor in my conversion. I give you total credit for figuring out the 1521 would fit, nice work....

Looks Awesome!!

[lincpimp]

Mmmmm! Looks excessive. I like it!

[_paralyzed_]

I've seen others solder on the connectors at a 90 degree angle to the wires with no problems, and that would keep it tight and clean looking, oh, btw, i'm also jealous

Here are some pictures of the reverse servo for everyone who uses it, like me and.....well, like me. Also the steering and brake servos final install with the receiver. Sorry for the bad pictures, I cannot take an in focus close-up to save my life! Any hints for close-up pictures?*Edit: I followed Neil's advice and used macro mode. What a difference! Thanks, Neil!