Dual Revo 3.3 BL conversion build-up

[Topspeedtimmy]

I have a new idea for a set-up for the Revo 3.3. how about this ESC: https://www.unitedhobbies.com/UNITED...idProduct=4691 with my 6s 3800mah 20c pack on a 12XL? I've seen one other person running this ESC and it seems to be good bang for the buck. Anyone think this a good idea?

[lincpimp]

Sounds like a good setup to me, give it a try and let us know. Metalman has used that esc, as have others on here. I think akqut has too.

[BL_RV0]

only thing i am worried about would be weight distribution. the apogee limn 3800 6s weighs in at 678g or 1lb 7.9oz. it seems like you would need stiffer springs on the right side, because thats where the battery would go.

[Topspeedtimmy]

Originally Posted by BL_RV0

only thing i am worried about would be weight distribution. the apogee limn 3800 6s weighs in at 678g or 1lb 7.9oz. it seems like you would need stiffer springs on the right side, because thats where the battery would go.

It's 2 different 3s packs and they are so tall and round that they cannot be stacked on the right side. So I was going to put the other one just in front of the transmission on top of the servo. An XL with heatsink is what, like 14 oz? The battery on the opposite side is 12 oz. so putting the other battery in the middle or slightly to the right should be fine. This might make it a little front-heavy but an XL motor might balance this out a bit.

Happened bring my camera along for my bash in the himalayas!