MMM availibility date dropped!

[jhautz]

Repeatedly eluding to the things that are "out of our control" is the tip that there is a possible slip on the horizon IMO. I do consumer product development project management for a living and that’s a sure fire bet that there is something (and all it takes is one little thing to delay it all) that has a high likely hood of slipping or has already slipped and they are in fire drill mode trying to right the problem and still pull off the March date.

Not saying that this is the case as I know nothing about what is actually happening, but that’s what it sounds like to me.


I hope they do pull off the March date as it would give me just enough time to get my truggy ready in time for the spring racing season. It starts April 13th and it would be nice to have the final setup, installed and tested for a week before the season starts, rather than trying to change it all over sometime in the middle. I have been holding off buying another speed controll anticpating the MMM, but its sounding like I might have to borrow a Quark from another truck and get it ready to go. Oh well I have 4-5 weeks before I have to make that call. Hopefully CC has some more definitive info by then.

Keep plugging Guys!!! Whenever it gets here I'll still be planning to get my hands on one as soon as its released! It sounds like it very close whether its march or April, at least its in the home stretch.


Is there some sort of Pre-Order waiting list we can get on?

[jhautz]

One more question... Is the motor going to be a smooth can or a finned can? I'm personally hoping for the smooth can because it fits in more places.

[MTBikerTim]

Originally Posted by jhautz

One more question... Is the motor going to be a smooth can or a finned can? I'm personally hoping for the smooth can because it fits in more places.

I'd say it would be a smooth can too for that reason. Plus all their other motors are smooth can. You can always slap a heat sink on even though it wouldn't be as efficient.