 |
|
|
|
 |
 |
what size heat sink? |
 |
|
 |
|
(#1)
|
|
RC Wanna BE
Offline
Posts: 340
Join Date: Jun 2007
Location: Southern Utah
|
what size heat sink? -
03.03.2008, 08:31 AM
What size RCM heat sink fits a 1950\7? Just wondering. Will not use the end piece. No worries.
Emaxx Tranny slipper modification (Strobe like) http://www.rc-monster.com/forum/showthread.php?t=9341 |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
RC-Monster Admin
Offline
Posts: 14,609
Join Date: Nov 2005
Location: Des Moines, IA
|
03.03.2008, 10:55 AM
19xx LMT motors are 36mm in diameter, just like Feigaos, so Mikes heatsink/clamp will fit sans clamp.
A 1950 is 76mm long, which is 2mm shorter than an XL motor, so if you use the HS/clamp, it'llbe a little short... |
  |
|
|
|
|
|
|
|
|
|
|
(#3)
|
|
RC Wanna BE
Offline
Posts: 340
Join Date: Jun 2007
Location: Southern Utah
|
03.03.2008, 11:49 PM
Thats perfect!!!! I was not going to use the heat sink as its #1 job anyway. instead of mounting it on the top of the motor like it should be I am swinging it under the motor. It will be used as a support more or less. The front end cap keeps pulling out of the threads inside the motor casing on the 1950. So it will be more a support than a heat sink.
Emaxx Tranny slipper modification (Strobe like) http://www.rc-monster.com/forum/showthread.php?t=9341 |
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Linear Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
