 |
|
|
|
 |
 |
 |
|
 |
|
(#10)
|
|
Always Willing to Obtain More Knowledge
Offline
Posts: 1,482
Join Date: Oct 2006
Location: Chicago
|
04.23.2008, 06:03 PM
I ment the drilling on the revo input shaft. How exactly did you drill that (revo shaft) out using the drill press because my bit just wont eat through that steel. what bit are you using and are there any strategys i am missing. Also out ouf curiousity about how far apart is the new hole(the one you drilled) from the existing one on the revo shaft.
|
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
