RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > Brushless

Reply
 
Thread Tools Rate Thread Display Modes
Old
  (#1)
rcjmaxx
RC-Monster Carbon Fiber
 
Offline
Posts: 150
Join Date: Dec 2004
Location: Fla
04.28.2008, 12:08 PM

The receiver is in the front of the chassis and the CCBEC is in the rear near the MM exactly where the Rx pack was prior the the BEC install.
Yes the red wire has been pulled(disabled).
Over the weekend I replaced the receiver with another I had laying around. But the results were the same,throttle glitching beyond 50 ft.My system is a Futaba 3PH NOT the newer 2.4.
Late last night I again replaced the receiver with the one from a car that I drive on a regular basis just make sure and completely rule out the receiver angle.I'll be test that this week.
   
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com