MGM 16018 auto-tuning problem

[Just go Play]

Originally Posted by david lamontagn

But could you tell me where is this reset button???
When i open the program on my computer, i can't see any reset button

Another thing, have you try to run your controler on cut off mode???
For me, when i run in cutoff mode, the controler "cut" after only 4-5min of run, but if i put it on reduce rpm mode, i can dump my pack without any problem, and i can't observe any reduction in performance thrue the pack.

I've a Flightpower 5000mAh, 4s.

Thank you!

There is no reset button... the one you want is the defaults button located bottom left side of the program window.

Yes I have a problem with cut off mode getting tripped earlier then reduce rpm does. I have old firmware so it's expected, but that is the only real problem so for me it's not worth it to send in for updating. Once I get the new mamba then maybe I'll send the MGM in. Maybe by then they will have a fully functional firmware ready.

Originally Posted by Just go Play

There is no reset button... the one you want is the defaults button located bottom left side of the program window.

Yes I have a problem with cut off mode getting tripped earlier then reduce rpm does. I have old firmware so it's expected, but that is the only real problem so for me it's not worth it to send in for updating. Once I get the new mamba then maybe I'll send the MGM in. Maybe by then they will have a fully functional firmware ready.

So i suppose you run it in reduce rpm mode?? And do you feel any sign of power reduction during your whole pack?? Do you feel that the controler reduce the power and the rpm of you motor when the pack is 1/2 or 3/4 empty??

And is the auto tuning realy help with performance or the controller??

If i experiment any lost in power in reduce rpm, i'll run it on race mode for sure.