BK Controller set up problem

[lutach]

You mentioned the bridge came unsoldered. Did the traces broke off or just where the solder was came off?

Originally Posted by lutach

You mentioned the bridge came unsoldered. Did the traces broke off or just where the solder was came off?

I think it just came unsoldered...if the traces broke off would it still work? If they did break off can they easily be replaced?

[lutach]

Originally Posted by evader

I think it just came unsoldered...if the traces broke off would it still work? If they did break off can they easily be replaced?

I have a BK that had the same problem. What I did was just expose where the trace is and soldered on top of it. The PCP trace that was on the bridge have to be removed. I wish I had it with out the black shrink wrap as I would take some detailed pictures for you. Contact GriffinRU, he'll have a solution for this.

[GriffinRU]

Do you have 6V or 5V UBEC? I had problems in the past with Airtronics receiver running at 6V from similar UBEC...

Originally Posted by GriffinRU

Do you have 6V or 5V UBEC? I had problems in the past with Airtronics receiver running at 6V from similar UBEC...

I believe it's a 6V UBEC. I originally had a JRRS300 receiver in it but it was doing the same thing so I tried the Airtronics receiver...but still no better...

[GriffinRU]

Do you have a picture of your ESC?
Do you need help in restoring connector/traces?

there are a couple pics on the first page of this thread. The esc is the one in the white shrink wrap I'm guessing?

I would love some help in restoring the connector/traces...I really have no idea what I'm doing

[GriffinRU]

Originally Posted by evader

I think it just came unsoldered...if the traces broke off would it still work? If they did break off can they easily be replaced?

Yes, restore your broken trace to match attached image.