BK Controller set up problem

[GriffinRU]

Originally Posted by evader

sorry, one more question...what's the best way to strip the wire in the middle like I need to?

Razor blade, two round cuts and one longitude cut.

well it appears the other jumper has come un-soldered aswell

Since the first one is going to the black battery lead does that mean the other one can go to the red battery lead?

[GriffinRU]

Originally Posted by evader

well it appears the other jumper has come un-soldered aswell

Since the first one is going to the black battery lead does that mean the other one can go to the red battery lead?

Hold on!
What other jumper???
Do not apply any power before attaching picture. Do not solder in random order.

the red one that isn't being pointed to in this picture has now come un-soldered

[GriffinRU]

Originally Posted by evader

the red one that isn't being pointed to in this picture has now come un-soldered

I am just wondering what you do to the controller...
Send it back I will fix it and epoxy everything around, so you can pull entire truck by wires.
If anything this last, unmarked wire, must be soldered to the tiny SMD resistor, cannot be soldered anywhere else. But then you can crack it if not done properly, carefully.

Originally Posted by GriffinRU

I am just wondering what you do to the controller...
Send it back I will fix it and epoxy everything around, so you can pull entire truck by wires.
If anything this last, unmarked wire, must be soldered to the tiny SMD resistor, cannot be soldered anywhere else. But then you can crack it if not done properly, carefully.

sent you a PM