Nitro 4-Tec conversion

[BL_RV0]

Can't wait to see pics! Hope that CC motor doesn't have heating problems. I had a 5700 in a Rustler that I only ran onroad, lowered suspension, buggy foams.... The motor got to 295* on 3s with 20/86 gearing.

[lincpimp]

Originally Posted by BL_RV0

Can't wait to see pics! Hope that CC motor doesn't have heating problems. I had a 5700 in a Rustler that I only ran onroad, lowered suspension, buggy foams.... The motor got to 295* on 3s with 20/86 gearing.

We shall see, if it does run too hot, I have a l can size aveox motor that is 2500kv. I can run it on 4s lipo. That motor should have plenty of power. Hopefully the motor mount and the al chassis will act as a good heatsink to draw the heat away...

[brushlessboy16]

Originally Posted by lincpimp

We shall see, if it does run too hot, I have a l can size aveox motor that is 2500kv. I can run it on 4s lipo. That motor should have plenty of power. Hopefully the motor mount and the al chassis will act as a good heatsink to draw the heat away...

It should, one thing though the whole car sounds the signal tone of the MM, with my outrunner and mount bolted righ to the chassis the motor vibrates the whole car so they whole car talks

[lincpimp]

Time for some pics. Here is the car mocked up with the parts I currently have. I have ordered most of the rest of the parts, and will hit up the lhs when they open tomorrow and see what they have.