Quote:
Originally Posted by mk351e
here's my system:
losi muggy
tekno neu 1515 1y
MMM V2
6S hyperion 4800
spektrum 3 channel radio
spektrum pro rx
futaba digital steering servo
deans connectors
i didn't plug and unplug a lot. BUT, every time i did, i had the appropriate resistor in series to charge the caps slowly - I soldered one up with deans on both ends for a nice finish! I used to install car stereos, so I know to charge caps! ;) Also, the controller was completely set up with castle link before it was put in the truck. I also read the instructions a few times before I did anything. And as I said earlier, I even upped the arming time on the MMM to 5 seconds to account for the spektrum delay. The radio and rx were already bound of course, and I am not new to spektrum - I've been using this remote for a couple of years. all settings were set to zero on the remote, except throttle endpoint, which was at 115%. the mystery pop happened during calibration - batts were plugged in and switch on.
basically, I feel i've crossed all my t's, and dotted all my i's, and i'm still scratching my head. again. I do feel however, that there is an uncanny similarity to the MMM v1 here, and I wonder if it's me and/or my system, but as I said, I'm completely lost at this point. I would love to open it up, but NOT b4 I call CC tomorrow.
here we go again.
|
Have you run this set up with another controller?
Threaded Mode
