|
08.12.2008, 12:43 AM
Downforce on this truck was never worked out... I gave up and went to 5s2p A123 and a MM/CCBEC, and ditched the mechanical brake. This setup ran well except the center-front Jato driveshaft couldn't stay on the motor shaft since it lacked the proper screw pin to secure it (just a simple set screw). Basically I'm giving up on the MT2, but its front end is going toward my Corr truck project and its other components will be useful elsewhere. This will also help create some new space 'cuz quite frankly I've run out. A 4wd 1/10 truck won't be missed, though, as I still have my CRT.5.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|
Threaded Mode
