Need response from a Castle tech for MMM question

[Pdelcast]

Just one thing from me, and then I'll shut up --

Make sure you don't leave any solder shorts -- good idea to use some wick and clean up the excess solder after removing the parts.

[joeling]

Also can use a multimeter to check adjacent pads to ensure there is no short. Of course got to realise that a couple of pads for the 2 smaller components are common.

If the eyes are failing, use a magnifying glass. Works wonders.

Originally Posted by Pdelcast

Just one thing from me, and then I'll shut up --

Make sure you don't leave any solder shorts -- good idea to use some wick and clean up the excess solder after removing the parts.

Regards,
Joe Ling