Batch 2 V2 MMM

[George16]

Patrick, your pm box is full.

Anyway, here's my message.

The replacement V2 which was shipped on Aug 28 and received last Friday, Sep 5th is dead. I started a thread about it under CC forum.

http://www.rc-monster.com/forum/showthread.php?t=14844

Anyway, I want to know if it's okay with you to do the BrianG mod and run it with my rx pack without voiding the warranty if something worse will happen. I know some forum members were given the go-ahead to do the mod without voiding the warranty since the MMM is not working naymore.

[jhautz]

Originally Posted by JeffEmbracedDC

My MMMv2.0 BEC outputs 6.05v. I assume they changed the bec from 5.5 to 6.0v when they designed the v2?

-Jeff

Originally Posted by Mister-T

6.05 volt unloaded, voltage may drop under load even if there is a regulation

My V2 puts out 6.0v and my V1 put out 5.42v. I definitly think it has been changed from the origianal 5.5V standard.

[xtremelimits285]

Originally Posted by jhautz

My V2 puts out 6.0v and my V1 put out 5.42v. I definitly think it has been changed from the origianal 5.5V standard.

Yep , i put the volt meter to my v2 MMM and im seeing 6.0v on the MMM's bec...

With my MMM plugged in & my Futaba Digital S9351 servo plugged into my Futaba 2.4Gh 6ch Rx i am seeing 6v-5.95v, an when turning the steering servo to full lock(left or right), im seeing 6v-5.9v...

Now just for 0.2-0.5sec it drops to 5.8-5.75v when turning, but thats when the servo first moves under a Heavy load / my hand pushing down on the frontend an holding it down, but after 0.2-0.5sec it goes right back up too 5.8v-5.9v even while still loaded up / me pushing down on the frontend....

So the lowwest the new v2 MMM's bec drops is 5.75v, Under a Heavy Load.