 |
|
|
|
 |
 |
 |
|
 |
|
(#6)
|
|
RC-Monster Admin
Offline
Posts: 14,609
Join Date: Nov 2005
Location: Des Moines, IA
|
10.03.2008, 04:18 PM
I wasn't running a Tekno tray in my Revo, but I too noticed bending on that support arm. I was running 14xGP3300 cells in brick form and that is quite a bit heavier than a fuel tank, as Shark pointed out. I did something similar to what he did, but added an extra L bracket brace to support the tray instead. One part of the L was the tray support, the other side of the L was attached to the inside of the chassis with bolts.
|
  |
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
