Looking for a muggy roller...

[BL_RV0]

Originally Posted by lincpimp

Already done that, way before I came here... Not sure if I want another. Anyway the muggy parts are for a custom chassis project... you will want to see (and own) what I have coming.

How'd you like it? I want to do a 6x6 MGT that shoots rockets and such for a project X.

[lincpimp]

Originally Posted by BL_RV0

How'd you like it? I want to do a 6x6 MGT that shoots rockets and such for a project X.

Looks like a decent truck, I found the tranny to be a bit on the complex side, but could easily be replaced with an emaxx tranny for simplicity and motor brakes... 6x6 project sonds like fun. I have been meaning to do that with a maxx truck, but wanted to make my own diff case for the double pinion center setup.

[BL_RV0]

I'd probably use a big outrunner or dual KB45's, or 1 HV KB45.

[lincpimp]

Originally Posted by BL_RV0

I'd probably use a big outrunner or dual KB45's, or 1 HV KB45.

Going hv with a kb45 sounds good. I have 2 xl kb45s and have been wondering what to use them in... I will say that the L can motors can draw some juice, but seem to stay reasonably cool in my gtp. I am sure 1 with 8-10s lipo would be plenty to move a heavy 6x6 truck!

[BL_RV0]

Originally Posted by lincpimp

Going hv with a kb45 sounds good. I have 2 xl kb45s and have been wondering what to use them in... I will say that the L can motors can draw some juice, but seem to stay reasonably cool in my gtp. I am sure 1 with 8-10s lipo would be plenty to move a heavy 6x6 truck!

I'm assuming it'll be ~20-22lb because it'll have rockets and such on it. You think the KB45 on 10s will handle it? I'll probably use this one:
http://www.hobbycity.com/hobbycity/s...idProduct=5158
With lutach's 10s ESC... On 10s... (duh) and gear for high 30's. Me and TDC57 will have some fun killing each other at November or December's SoCal bash!

[lincpimp]

Should run cool at 25k rpm max, and will have tons of torque.