MMM V3 - First Run Opinions

[GT35R]

Originally Posted by e-mike

if i understand the esc come hot because you used 2 servo and a fan??????

Yeah well the BEC would have heated up under the load, and I could tell that it was struggling to move both the servos when steering side to side on the spot.

[macr0w]

My V3 is "bone stock", except for the fact that I removed the male bullets from the included wires and direct soldered all of them to the female bullets at 90 degrees.

Then I drilled a bunch of holes in the case to vent the caps a bit.

Oh yeah, I did try and secure the fan wire too.