LT-10s in a e-revo

[sikeston34m]

[QUOTE=hoovhartid;234936]I run it on 6s zippies(two 3s)....as it is, the kb45 has MAD power. I cant imagine 10s. way too much.

these may be good for 8s tho
http://www.hobbycity.com/hobbycity/s...idProduct=6418
or
http://www.hobbycity.com/hobbycity/s...idProduct=6503

Thanks Hoov,

I run a 6S 20C 5000mah setup geared 18/40 Mod 1 with a Medusa 36-60-1500kv. It's pretty quick.

I'm sure your kb45 setup is awesome.

8S would be too much for either of these setups, but that's where you change things around somewhat.

Maybe 1000kv motor geared correctly on 8S, then try to "tame" it some with Punch Control?

[hoovhartid]

Originally Posted by sikeston34m

Maybe 1000kv motor geared correctly on 8S, then try to "tame" it some with Punch Control?

I'm still a noob when it comes to the LT ESC. But as far as I know, there isnt really a punch control. I had to raise the "StartForce" to 12% to control cogging, but when it goes...IT GOES. There is no way to really get my truck to crawl anymore like it used to with my MMM/neu set-up. At least not with the settings I am using. I still need to tinker with the LT-10S a bit.

I will say this tho....when I ran my MMM/neu I was using 100% punch control and I could still get all 4 wheels to spin out on the track when I wanted to.
I just miss the slow control I had with the MMM. I could get the e-revo to crawl over a parking bumper.

i have overpower issues

[lutach]

The best thing to use to control the throttle is finger control lol. I did notice that the ESC has a pretty high starting RPM, but that might be because it's needed for cars.

[hoovhartid]

Originally Posted by lutach

The best thing to use to control the throttle is finger control lol.

there isnt another setting i can try?

I have been in RC for about 22 years. I have finger control.
But when I just barely start to pull the trigger....its GOES....almost enough to get the front tires to hop off the ground.

Maybe I can adjust my DX3.0 in some way?