 |
|
|
|
 |
 |
 |
|
 |
|
(#27)
|
|
RC-Monster Stock
Offline
Posts: 34
Join Date: Aug 2005
Location: australia
|
11.21.2005, 09:21 AM
i give the shaft a bit of a tap .. and the rear endbell should pop off .. then slide out rotor ,, be carefull of that rare earth magnet !!! , then replace bearings .. refit .. and make sure u use rc-monster heatsink motor clamp .. too easy .. ohh an tape over the rear bearing ,
|
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
