Single speed tranny w/ lexan cover and motor mount.

[Semi Pro]

cool gee i like the led look

[SnoopMaxx]

Absolutely Astounding

[JERRY2KONE]

Like I said once before Gee you have some good creativity. Your design is pretty basic and it seems like any of us should be able to do something like that, but it takes determination and patients to stick with the plan and actually complete the project in such a short time. The only weak point I see is where your bearings are sitting. The area of lexan that was left after your machining process is pretty thin where the bearing seats. You may want to "Gorilla" glue a disk of something over that area to reinforce it, to make sure that it does not break loose on you. I would hate to see all of your work ruined by such a little detail.

The LED's are a pretty nice treatment that will get some added attention for your truck when it is in action. Nice work Gee.

[SnoopMaxx]

Was the REVO style slipper a direct fit ?
Or did you have to modify it ?

[lincpimp]

Originally Posted by SnoopMaxx

Was the REVO style slipper a direct fit ?
Or did you have to modify it ?

You have to use a revo (nitro) input shaft, and either drill a new hole for the top gear, or drill a new hole for the pin that hold the slipper hub. It will only work with the single speed cause the revo input shaft is not long enough to mount both gears from the emaxx. Good mod, as the stock slipper sucks...

[SnoopMaxx]

Thank´s lincpimp
how ´bout the 3905 2speed top shaft on the 3906 will that work ?