Ofna DM-One Brushless Conversion (DM-1)

Originally Posted by BrianG

The Ofna single speed spur setup uses the 51T spurs: http://www.rc-monster.com/proddetail.php?prod=ofn30110

Luckily, I happen to have a few from the old days when using an emaxx tranny with strobe slipper setup was common.

Note about the Ofna single speed kit: It does not come with support bearings or outdrive cups so you need to get those seperate. Also, my kit did not come with the needed grub screw, which is 5mm.

Ok. I am up to speed with the 51T spur--I will have to order one (or two!). As far as the center single-speed kit I installed that today (I will post pics soon). I used the center shaft from the 2-speed and seems to work fine--this way the bearings and out drives fit without issue. What is with the missing 5mm set screw?

Thanks for your help. Cheers!

[year1camaro]

I got a few more things done over the weekend. New Feigao 540XL is the first motor I'm tryin out.(we'll see if it sticks) The stock clutch bell and 2 speed gears are mounted to it. I made the radio tray up to support the receiver, antenna and brake servo also, one bolt and it swivels out for cleaning.
I'm still waiting on six 30C 5000mah lipo cells to come in the mail. I'm gonna start it out on four cells and see what happens. I was wondering if anyone out there tried to run the DM brushless with the 2 speed? Any suggests, complains or praises?
I know the one down fall is no reverse, but I'm not sure how important that will be for parking lot racing. Thanks for comments and suggestions in advance.