G2r Revo Project

[Hardstyle]

Omg the dang thing burst into flames and got hit by a tractor
Juuust kidding!


Powering first time the system had some difficulties. Fan keeped blowing, Leds were all on and no response throttle nor steering. Figured that I didn't Bind my receiver with the radio after making a new profile for it. So it didn't get signal.

Did a little test run outside. It runs very well, can't really say about the performance yet, traction isn't best at ice/snow. Front wheel flyed off though..
Throttle is smooth as a butter, a light year ahead from my bk controller. Temps were quite normal for this weather motor 30C° controller 35-40C° outside 0C°. Batterys were... cold


And another thing. I was suprised that 14t mod 1 pinion was too small. It barely touched the spurs teeths.. So had to settle for 16t.

I tweaked Esc's settings a little. Should I change something?And about the brake amount, is it all the same if I tune it from the radio or from the esc's setting?

[feistyacorn]

I have things adjusted a little different, but not by much. I have the punch control at full power, alot less brake, smaller throttle deadband, auto lipo, and a faster arming time. Just pp on how you want to run your truck. If I were you I wouldnt mess with the punch control, you can use your transmitter to tame your truck if it is too wild. I usually slow my trucks down when I go to the track and speed them back up for bashing. I get too power happy at the track.