Got an Emaxx

[Takedown]

We'll if anything does go wrong then you can always send it to castle with the replacement/repair fee which IIRC is $50 for a replacement/repair when not under warranty. Or just buy another MMM if all else fails. When I ran the MM on my e-maxx it preformed decent. I always had to run a fan over it because it got quite hot. I ran the MM on 5s a few times without issues but it got hot even with a fan running on voltage that its not meant for "8v". I really wanted to get ahold of a MMM but funds werent sufficient at the time.

[Krawlin]

Originally Posted by brushlessboy16

Yeah, i havent seen him in a while..

Just picked up a MM and cc Bec for 60 bux (thanks chris) for the maxx.
20 bux left atm, gonna be idlers most likely. But on the bright side i can run my 4s zippy lipo with the brushed motors

Originally Posted by Takedown

Wasnt that the MM that was turning off every 5 seconds...

Originally Posted by brushlessboy16

He Ironed out the problems apparently.. we will see..

Tried it on my CMS6900 motor and it worked just fine. Ian and I think you (Ben) told me that it was just going into overamp protection anyway. And when I plugged in the CMS6900 a few weeks ago before I soldered up the 6.5mm bullet connectors, on 2S the motor spun just fine throughout full throttle range for about 5 minutes. And even when it would shut off and on with the Medusa, it would never actually get hot and it would only do it when I couldn't keep it above like 1/2 throttle, and Ryan told me that motors pull more in those lower RPM's which would explain why the MM was going into overamp protection only when I couldn't keep it above a certain speed.